Skip to content
Made by hand in San Diego California since 2009 • Custom made to your size for only $298 • 99% of all orders ship within 24 hours!
Made by hand in San Diego California since 2009 • Custom made to your size for only $298 • 99% of all orders ship within 24 hours!

Phalloplasty

 The Elator Before and After Attached

The Elator was primarily designed for cis men (a cis man is someone who was assigned male at birth and also identifies as that male gender) with erectile dysfunction. However, over the years we have found that FTM transgender individuals who have had Phalloplasty have been using The Elator as well. As long as there is a constructed head of the penis (commonly known as glansplasty), The Elator can attach normally and provide rigidity. The pictures to the right show a completely flaccid penis before and after The Elator has been attached. Keep in mind that the model is completely flaccid but The Elator can be attached while partially or fully erect. We created this page to offer guidance for any Trans Men who have questions about the Elator. The measuring will be different for trans men.

You can find some Phalloplasty client testimonials here.

Measuring Tips

We wish we could give you clear cut instructions. What we have found is that each penis is constructed differently.

The phalloplasty penis is not as elastic so the girth does not have to be as tight as shown in the standard measuring video.

As for length… when we get a measurement we make adjustments… for example… if someone orders a 13 (6 1/2") we ship a 10 (5"). We do this because you are measuring to the tip but The Elator attaches behind the head of the penis. A phalloplasty the head can be 1” to 3” so our normal adjustment does not work well all the time.

The other factor is The Elator attaches underneath the penis and without testicals to stop the shaft from sliding back the length should be a little longer.

So far are 50% of our phalloplasty clients end up needing to buy a 2nd shaft ($148).

Our suggestion… measure as instructed BUT measure to the back of your penis head versus the tip and then add 1 size (this accounts for the extra length needed underneath). When ordering, there is a notes section. Make sure you type “DO NOT ADJUST LENGTH - I HAVE A PHALLOPLASTY PENIS”. As for girth… make it tight enough so its snug enough to not slip off easily but not to snug where its cutting off blood flow.

If you have tried the Elator and would like to offer input and tips to be posted on this page please email us at sales@theelator.com

The Elator is Custom Made to Your Penis Size

 

 

The Elator includes a hand made, custom shaft, 4 base rings in various sizes and a carrying case

The Custom Made Shaft Is Constructed With Stainless Steel Medical Grade PET and Silicone

 

 

The Custom Made Shaft Is Constructed with Stainless Steel Medical Grade PET and Silicone

The Front Loop of The Elator Expands To Allow For Growth and or Shrinkage

 

 

The front loop of The Elator is a stainless steel frame with a spring on the top 1/3 that allows for some expansion

The back clip attaches to one of the 4 included base rings

 

 

The front loop of The Elator is a stainless steel frame with a spring on the top 1/3 that allows for some expansion

Each complete Elator includes 4 base rings of various sizes

 

 

Each complete Elator includes 4 base rings of various sizes

The support bars of The Elator are stainless steel but they are only as thick as a penny

 

 

The support bars of The Elator are stainless steel but they are only as thick as a penny

The support bars are flexible but sturdy enough to support your penis

 

 

The support bars are flexible but sturdy enough to support your penis